Your replacement cartridge pack is created for the Filteroo® Steel and Superoo GRAVITY WATER FILTERS. But it is suitable for any gravity water filter that these cartridges will fit inside to create fresh gravity filtered water.
Learn more about your cartridges by clicking through the links below:
Test Results
How To Prime your 5.5” & 8” Filteroo® Rain & City Water Carbon Block Gravity Water Filter Cartridge
How to Install & Flush 8” Filteroo® Rain & City Water Gravity Carbon Block Filter Cartridge
How to Backwash your 5.5" & 8" Filteroo® Rain & City Water Gravity Carbon Block Filter Cartridge
Test Results
Contaminant Removal | Performance | Capacity in Litres* |
Chlorine | 99% when new, >90% for the life of the cartridge | 2000L |
Chloramine | 99% when new, >90% for the life of the cartridge | 1700L |
Lead Lead pH6.5 @150ppb (NSF53) |
99% when new, >90% for the life of the cartridge | 1500L |
Bacteria | 99.99% for the life of the cartridge | 1500L |
Cyst | 99% when new, >90% for the life of the cartridge | 2000L |
How To Prime your 5.5” & 8” Filteroo® Rain & City Water Carbon Block Gravity Water Filter Cartridge
How to Install & Flush 8” Filteroo® Rain & City Water Gravity Carbon Block Filter Cartridge
- Remove the locking nut from the cartridge threaded stem leaving 1 sealing washer over the end of the cartridge threaded stem.
- Insert the filter cartridge threaded stem through the hole in the top tank from the inside out.
- Then secure by screwing the locking nut onto the threaded stem on the underside of the top tank until tight. Do not over tighten.
- Ensure that the tap is in the off position.
- Fill the top tank with cold water and allow this water to filter through to the lower tank.
- It is recommended to drain the first filtered water to waste as it may contain carbon fines.
- Open the tap and allow the water to empty the bottom tank into a bucket or container. You can use this water for your garden or plants.
- We recommend flushing at least 12 litres of water through the cartridge using the process in steps 5 - 8.
- Please Note: If you are going to install the Filteroo® Max Fluoride Removal Cartridges also, flush 12 litres of water through the black carbon cartridges at this time. As after you have flushed the fluoride removal cartridges & connected them as per the instructions, you can flush another tank of water through both the carbon cartridges and the fluoride removal cartridges together at the same time. Please see the Filteroo® Max Fluoride Removal Cartridge Installation and Flushing Instructions.
- The filter is now ready for use.
The 8" carbon gravity cartridge lasts for 12 months or 2000 litres whichever expires first. Note: If you use 2 cartridges in your water filter the cartridge capacity will increase to 4000 litres or 12 months whichever comes first.
How to Backwash your 5.5" & 8" Filteroo® Rain & City Water Gravity Carbon Block Filter Cartridge